Categories
Touring Bicycles

Surly Straggler

picture of bike on snowy trail
This is the Surly Straggler bicycle. It’s similar to a Surly Cross Check but with a few crucial differences; most notably the Straggler has disc brakes and comes stock with Surly Knard 700c x 41 tires. Surly sent us this bike to try out after the Interbike trade show in September and I have had the chance to ride it a few times now. The first thing I notice is that the handling is different than my Cross Check. The steering feels more nimble and responsive. The other thing is that although this is a 56cm frame and my Cross Check is a 58 this bike seems to feel fine fit-wise. Not surprising once I look at the Surly geometry chart and see that the 56cm Straggler’s effective top tube length is identical to the 58cm Cross Check top tube.

But why does the handling feels so much different I wonder. The seat tube and head tube angles are the same on both bikes, so I’m thinking the bigger tires change the fork trail pneumatically. Also, the bottom bracket drop on the Straggler is 6 mm greater than on the Cross Check and the Straggler’s chain stays are half a centimeter longer- both of these are probably in consideration of the bigger tires for which the Straggler is designed (the increased bottom bracket drop makes the standover height manageable),but they can’t help but affect the handling of the bike.

There are a couple of quirky details which I think are unique to Surly (no surprise, that);
-The rear dropouts are a “partially closed, horizontal design” made to accommodate single speed set ups or derailleurs. When used with a derailleur, the rear wheel slips up into the vertical part of the dropout where it is held in place partially by the clamping force of the quick release but also by the set screw threaded in from the rear of the horizontal part of the dropout. In a single speed application the wheel slips into the vertical part and then slides back in the horizontal part to tighten the chain and is partially held in place by the same set screw which in this case is threaded in from the front of the dropout.
-The front hub is Surly’s Ultra New Hub which features a hollow axle for standard quick release but the inside ends of the axle are threaded. Surly provides two stainless steel bolts with caps which thread into the ends of the axle and clamp the wheel in place. This setup gave me a sense of added security over a quick release- especially with disc brakes which place a lot of torque load on the hub.

dropouts
The “partially closed horizontal” dropouts.

 

The fixing bolt cap on the Surly Ultra New Hub is heavily knurled to help hold the wheel securely.
The fixing bolt cap on the Surly Ultra New Hub is heavily knurled to help hold the wheel securely.

 

handlebar and brake hoods
The Salsa Cowbell 2 handle bar felt very good with the Shimano Tiagra brifter hoods. The bars have a very short top ramp but it mates nicely with the hoods creating a nice flat cradle for the hands.

Overall Impression and Conclusion.
I already noted how even with the big Knard tires the bike’s steering is nimble and responsive but these tires roll nice too. The bike feels quick in every way, and the tires felt nice and stable on the snow packed trail I rode.
I am in my retro-grouch phase now but I have to admit I like the brifters on this bike. Even though they are Shimano Tiagra level, the shifting is precise and easy and being able to shift without moving the hands is pretty important on any technical terrain. Like all Surly bikes there is nothing especially fancy about this bike but everything works and the bike is solid. This “Glitter Dreams” color is a love it or hate it proposition- I happen to love it- but they also make the bike in black.
It’s not technically a touring bike but it has all the braze-ons and clearances for racks so one could call it a camping bike. It also is a great bike for just ripping around in the hills on single track or gravel roads. It makes me want to go for a ride and that can’t be bad. I like this bike a lot- in fact when Surly asks for it back I will probably buy it.

Categories
Rear Racks

Salsa Wanderlust Rear Bicycle Rack

Recently I experienced some discomfiture when I realized the Salsa Wanderlust rear rack would not fit on a Surly Long Haul Trucker. Because the top platform was so long and extended so far forward it actually came into contact with the seat stays, making it impossible to mount the rack so that the top platform was level. Apparently the rack was designed to fit certain Salsa bicycles; those with pronounced top tube slope, short seat stays and lots of seat post showing. This implied a positive short sightedness on the part of Salsa. The expression of my discombobulation to the good folks at Salsa seemed to go unheeded.

More recently we restocked our Salsa Wanderlust racks and brought in one of the new Heavy Duty versions of the rack. Turns out somebody was listening! Both versions of the rack have been redesigned and now fit beautifully on the LHT and Disc Truckers as well as the Cross Check and, I imagine, most other bikes. (as of 12/9/2013 the Salsa site still says-“NOTE: Designed as a rear rack solution for Salsa Fargo and Vaya frames. This rack may not work well with traditional touring frames that feature level toptubes.”)

rear rack on surly bike
When mounted on the 700c Disc Trucker there is plenty of clearance to the seat stays. Notice how far rearward the top platform sits.

rear rack on bike
The H.D. version of the Wanderlust sits a little lower than the standard version, but still clears a 700c wheel

pannier bags on rear rack
Panniers are back and down on the Wanderlust racks; good for bikes with shorter chain stays, such as cross bikes. (Your heels won’t hit the bags)

The new Wanderlust racks place the top platform well behind the seat stays, lower than most other racks. The middle pannier carrying rail is lower too. This means you can get your panniers low and out of the way of your heels if you have relatively short chain stays. (touring bikes will have chain stays in the 44 to 46 cm range, measured from the center of the crank to the center of the rear dropouts). The other thought that occurred to me is that there might even still be space for a capacious saddlebag; say the Frost River Caribou Trail for example, in addition to a bag on top of the rack.
two racks
The wanderlust H.D. on the left has a slightly narrower top.

racks side by side
The H.D. version in the foreground is wider at the bottom.

Salsa rack hardware
Simple, robust hardware.

wanderlust and logo
With the lower attachment points more or less aligned it is apparent the top platform of the Salsa Wanderlust (in front) will be well aft of that on the Tubus Logo. (rear)

This didn’t start out as comparison between these racks and the Tubus Logo but one is inevitable since the new heavy duty Wanderlust is in the same price range; $140 for the Salsa Wanderlust H.D. and $150 for the Tubus Logo. Both racks are made of steel but the Logo is lighter by almost half a pound or 195 grams. I weighed the Logo at 1 lb. 13 oz. (840 grams). The Logo also has a greater rated load capacity at 40 kilograms or 88 pounds, whereas the H.D Wanderlust has a rated capacity of 25 kilograms or 55 pounds. The standard Wanderlust is made of aluminum and weighs in at 800 grams or 1 lb. 12 oz.; close to the weight of the Tubus Logo, but it has less rated capacity at 15 kilograms or 33 pounds. In fairness it also costs $55 less than the Logo.

These new Salsa racks get the Bike Hermit™ Seal of Approval. For those who have bikes with shorter chain stays but still want to carry a pretty significant load, the Wanderlust H.D. is a good alternative. And the standard Wanderlust is a sturdy, well designed rack that should handle most bicycle touring duties with equanimity.

Categories
Advocacy/Awareness

Don’t Be Left Out.

Last weekend we offered free shipping on all orders placed in the Bike Touring News Store. We also sent out an email blast to local customers about “Fatbike Sunday”. While we sold no fatbikes we did have a pretty good response and some people who were paying attention and came into the store got some really nice prices on accessories. My point is this: you should sign up to be on our mailing list. We send out an auto-responder which is a bi-weekly text email and we send out a newsletter every month or so. In between, we send out notices of special promotions or upcoming events. So sign up to be on the mailing list. You can use the form below or the form in the right sidebar.

Subscribe to our mailing list



Bike Touring News


    If you would like to get updates when there is a new blog post then get the syndicated feed. That too can be accomplished by clicking on the “Syndicate This” link in the right sidebar or by clicking here.
    Thanks for your attention.